Brakes

brakes, calipers, rotors, handbrake, brake fluid reservoir

Kriss Motors says:

The door glass regulators (that move door glass up and down)...
Garrycov says:

How did you remove the door window winders?
Kriss Motors says:

We installed the standard box with 15 fuses and 7 relays...
martystep says:

When you purchased the Classic Technologies Fuse Box, was there an...
Kriss Motors says:

We used tack material from kanter.com, a site that specializes in...
happy170 says:

Looks nice, what was the tack strip material used?
Kriss Motors says:

See https://krissmotors.com/Mk2/?p=7111 We used rivets to fasten the new strips instead...
erik juelsen says:

Did you glue or use tacks to fasten new replacement strips?
happy170 says:

im missing the passenger side under dash panel (LHD) for my...
Kriss Motors says:

These clips were sourced from XK Unlimited about 9 years ago.
tommyrae1234@gmail.com says:

Where did you source the fuel/brakeline clamps that I see in...
Kriss Motors says:

Avoiding any constraint on the cable should be the primary objective.
Eric Tyler says:

Eric, Another question, if I may. When the cable comes up...
Kriss Motors says:

Your cable path sounds good. There may be slight differences between...
Eric Tyler says:

Eric, I have a LHD 3.8L MOD. I also have a...
Kriss Motors says:

Allan, sorry but your question isn't clear. Are you referring to...
AllanWood says:

Can you please tell me the seal orientation for the seal...
Kriss Motors says:

Correct. We used slit rubber hose so the sleeve could be...
Eric Tyler says:

Eric, Would you mind relating what product you used for the...
Kriss Motors says:

The Insulation Plan graphic above shows what we did. The floor...
happy170 says:

I removed existing tar and fiber on floor completely. My question...
Kriss Motors says:

Try SNG Barratt, for example a long wire replacement.
happy170 says:

Where can I find replacement spokes for the wire wheels 72...
Kriss Motors says:

Thanks to Tony Tinari for all these beautiful photos. Tony, the...
Eric Tyler says:

Eric, I plan to buy the studs (from SNG) with rubber...

assemble blast clean disassemble fabricate fit machine modify paint replace research restore test weld