Suspension

front and rear, shock absorbers, springs, cross member, panhard rod

Actis says:

The wiring for the b column went up the column or...
Kriss Motors says:

Avoiding any constraint on the cable should be the primary objective.
Eric Tyler says:

Eric, Another question, if I may. When the cable comes up...
Kriss Motors says:

Your cable path sounds good. There may be slight differences between...
Eric Tyler says:

Eric, I have a LHD 3.8L MOD. I also have a...
Kriss Motors says:

Allan, sorry but your question isn't clear. Are you referring to...
AllanWood says:

Can you please tell me the seal orientation for the seal...
Kriss Motors says:

Correct. We used slit rubber hose so the sleeve could be...
Eric Tyler says:

Eric, Would you mind relating what product you used for the...
Kriss Motors says:

The Insulation Plan graphic above shows what we did. The floor...
happy170 says:

I removed existing tar and fiber on floor completely. My question...
Kriss Motors says:

Try SNG Barratt, for example a long wire replacement.
happy170 says:

Where can I find replacement spokes for the wire wheels 72...
Kriss Motors says:

Thanks to Tony Tinari for all these beautiful photos. Tony, the...
Eric Tyler says:

Eric, I plan to buy the studs (from SNG) with rubber...
Kriss Motors says:

Right on spec ... you are good to go!
Peter Boston says:

Hi, done a Compression test today on my Mk2 2.4 (1967).
Eric Tyler says:

Thank you! Eric
Kriss Motors says:

There wasn't any padding on the original installation, and we elected...
Eric Tyler says:

Eric, Regarding the vinyl skirt wrapping the base of the rear...
Kriss Motors says:

The headliner should be glued to the back and front window...
Peter Boston says:

Hi, when you put your headliner in did it go inside...
Kriss Motors says:

As indicated on the diagram, we doubled up the tack strip...
Eric Tyler says:

Eric, I purchased the 3/8" X 1/2" convertible tack strip you...
Kriss Motors says:

We used engine oil. Not sure it matters very much since...

assemble blast clean disassemble fabricate fit machine modify paint replace research restore test weld