See prior discussion of fan conflict with the brake servo. How to trim a stamped steel fan with twisted blades? It can’t be held in a bench vice. An attempt to mill the fan on a rotary table failed because the extended blades created too much “chatter” against the cutting…
TOOLS
MAJOR TOPICS
-
Kriss Motors says:Avoiding any constraint on the cable should be the primary objective.
-
Eric Tyler says:
-
Kriss Motors says:
-
Eric Tyler says:
-
Kriss Motors says:
-
AllanWood says:
-
Kriss Motors says:
-
Eric Tyler says:
-
Kriss Motors says:
-
Kriss Motors says:
-
Kriss Motors says:
-
Eric Tyler says:
-
Kriss Motors says:
-
Peter Boston says:
-
Eric Tyler says:
-
Kriss Motors says:
-
Eric Tyler says:
-
Kriss Motors says:
-
Peter Boston says:
-
Kriss Motors says:
-
Eric Tyler says:
-
Kriss Motors says:
-
Sam H says: